November 26, 20187 yr I just installed the GTN750 in X-Plane 11.25 last night and got it to work perfectly on a few aircraft that were setup for it. But a strange thing occurred. After the instillation when I went to start up the sim, every aircraft needed me to input the authorization codes again! What a pain. Not sure that should be happening but though I'd let you know. Now the next challenge is to install the device in aircraft not already coded for it.
November 26, 20187 yr 2 minutes ago, steves53 said: every aircraft needed me to input the authorization codes again! Hi, Do you mean the "X-Plane activation code" ? Edited November 26, 20187 yr by RXP
December 2, 20187 yr Author No, each Carenado aircraft's authorization code so far as if I was installing for the first time. No big deal but had to dig out old emails to find them. New issue: I also had a crash to desktop last night for the first time ever with X-plane. I was flying the C210T to PHJR in Hawaii and couldn't find any approaches or procedures in the 750's database at all for that airport. So I looked on the lower GNS 430 and found three approach procedures and when I tried to load one, X-plane crashed to desktop. Are there any good tutorials on installing in aircraft that aren't already setup for it?
December 2, 20187 yr Hi, was this he X-Plane 430 or the RXP GNS V2? As for installation, this would be a good start: Then:
December 2, 20187 yr Author Thanks for the quick responses! It was the x-plane 430 that I was programing when the crash happened and it automatically sent a report to X-Plane after the crash.
December 6, 20187 yr Carenado says to me that they Sasl must be updated since x-plane 11 30 beta. X-Plane 11 -My favorite aircraft F33A BONANZA XPLANE 11 REP , CAR PREMIER 1A
Archived
This topic is now archived and is closed to further replies.