Hello,
I would like to address an already mentioned mistake again in the CONIG-CALLOUTS.
It is the option 1000 Feet (Approach) setting.
If you only go to the page CONFIG-CALLOUTS and the option is for example NO and this is not changed, now just another button, for example to DEP, then back to CONFIG-CALLOUTS, an unintentional change of the Option 1000 Feet (Approach). It automatically switches between YES and NO. Again and again when you leave the menu and go back.

Please check and change if possible.

You never know which setting of this option is really active then.

If you want that, I can shoot a small movie and send it to you to watch.

 

Thanks, benne36

I could never reproduce that.

But yes, please make a movie so I can see it.

 

here the link to the little movie

 

https://mega.nz/#!dEwSharY!PI_ZU6YoiTq0CV0APFQB4IQ5hnanI_9YwkChdWRZ9h8

 

about google

 

https://drive.google.com/open?id=1_aCzDbuzsLfE-Brvq7VBOw068g1mAh_W

Edited August 17, 20196 yr by benne36

Thank you.

The video was very helpful.

I can reproduce it now, which means I can fix it easily.

Cheers,

Thank you for your efforts.
Super software from you.

13 minutes ago, benne36 said:

Thank you for your efforts.
Super software from you.

Thanks, send me a support ticket.  I need you to confirm the fix I made.

Best,

 

Support ticket sent. Do you need the ticket ID given there?

Thank you. Now it works without problems. You can change without it changes.
Many thanks