Hello again

I have installed LINDA 3.11.854 all runs OK

I have d/loaded module PMDG_737NGX_v4.15a.  After I have unzipped the folder and copy & paste folders LINDA & LINDA-CFG into the P3D Modules folder, I receive the following message when I run LINDA

"A serious problem has been found VRInsight config creation error Exiting Linda"

 

Please advise

Thanks...Clive

 

Hi Again

I may have resolved the situation.  Although I had cleared the registry file of LINDA entries I may have been inserting the modules folders into the P3D modules folder incorrectly.

What I was doing is deleting the two module folders (LINDA & LINDA-CFG) and then copy and pasting the new module folders into the P3D Module folder.

The new method I have used is not to delete the module folders (LINDA & LINDA-CFG) inside P3D module folder but to copy and paste the new module folders over the top of the existing module folder withing P3D.

Although my new method has worked I am not sure whether it is the procedure that I was doing incorrectly or I have cleared a problem inside the registry file by deleting entries called LINDA

Clive

P.S  I think the error was that I had adopted the wronf procedure transferring module folders

Do you have a VRI Combo panel? If so make a copy of the config-mcpX.default in the /modules/aircrafts/LINDA-CFG/PMDG 737NGX folder and change the extension to .lua. 

The ‘new’ method you describe is exactly as the module Manual install instructions are written if followed. By dropping the supplied folders into the modules folders only those files that are changed will be overwritten. There is no need to delete any of your existing folders or files. Any existing configuration files will remain unaltered. 
 

The Maintenance page offers an automated method for installing modules. All you have to do is select the downloaded source folder and LINDA will do the rest.