Hi everyone

Thanks to Dave I have the program running now.

I am ok with the ATC procedure at the start of flight.. ie. Clearance request. Push back/ push back engine start...taxi..

Can some one please advise what is the sequence after this.

At runway holding point it only advises take off...it does not say line up ...etc. I used Proatc x. And this always says line up etc..

Also during flight it stays mostly silent.

Finally can you please advise the steps when near destination airport. What do I choose from the approach option for ils landing.

Many thanks .

Qas

 

Hi, 

If there is a trigger point close to runway you are transfered to tower and can request take off. Sometimes the trigger points (hold short) are not defined for 100 percent at the correct position within scenery . If so I switch to tower on my own and request for take off. After that I will normally transfered to departure, center and so on... 

Kind regards 

Peter 

Many thanks for the help.

what are the steps after take off-in particular near destination airport.

I am uncertain on how pilot 2 atc  manages the landing process.

Do I contact approach at about 30 miles out-or wait and approach will contact me automatically. 

In sayit there are so may phrases to choose.

I am following you-tube tutorials .

Many thanks.

Qas

 

Hi Quas, 

In generally you are requested by active controller to contact next controller. If so you switch to the given frequency and check in to the next controller. 

Sometimes I also have the feeling that the transfer from center to approach is late or completely missing. So I switch Frequency manually too and check in to him. 

Hopefully this is helpful. 

Best regards 

Peter 

Many thanks to everyone-I have much better understanding of the whole process now,

All the best.

Qas