May 3, 20206 yr Hello all of you, First of all, i hope everybody is ok during this difficult period. I have purchased Carenado PC12 Pilatus for P3D V4.5 few days ago because i was looking for a new "small" fast aircraft. I am a bit disappointed : - There is of lack of documentations of the software hitself (panel description, tutorial flight,...) - There is starting bug with ignition auto. I found you get this bug if you use "Cold&Dark state from Carenado setup" - I also do not see the blue light and light testing when activating the STBY BUS as we can see in this video (https://www.youtube.com/watch?v=ZOO3XvimoUI) - No VC textures Anyway i will fly this aircraft as i have it but i have read Bert Pieke made a Panel Mod for PC12. Do you know how to find it ? I wrote him a PM but i do not know if this is the right way. Thanks for answer Franck X570 Aorus Ultra - AMD Ryzen 7 5800X3D - Gigabyte RTX 4070 - 34 Go Ram DDR4
May 3, 20206 yr 3 hours ago, af1134 said: Hello all of you, First of all, i hope everybody is ok during this difficult period. I have purchased Carenado PC12 Pilatus for P3D V4.5 few days ago because i was looking for a new "small" fast aircraft. I am a bit disappointed : - There is of lack of documentations of the software hitself (panel description, tutorial flight,...) - There is starting bug with ignition auto. I found you get this bug if you use "Cold&Dark state from Carenado setup" - I also do not see the blue light and light testing when activating the STBY BUS as we can see in this video (https://www.youtube.com/watch?v=ZOO3XvimoUI) - No VC textures Anyway i will fly this aircraft as i have it but i have read Bert Pieke made a Panel Mod for PC12. Do you know how to find it ? I wrote him a PM but i do not know if this is the right way. Thanks for answer Franck PM is good, inluding your email address. Bert
May 20, 20206 yr Hi, I've got a serious issue with my PC12 namely the autopilot is freaking out, not following neither heading nor GPS, it banks 90 degrees to the sides causing aircraft to crash. This is very strange. Have you seen that before? What might be the problem ?
June 2, 20206 yr I've seen that. I'm my case, I had to remove an entry in the prepar3d.cfg: stick_sensitivity_mode=0 under [Controls]. Best regards, Dimitrios 9950X3D - 64 GB - RX 7900 XTX - TrackIR - Power-LC M39 WQHD - Honeycomb Alpha yoke, Saitek pedals & throttles in a crummy home-cockpit - MSFS for props, P3D for jets
Archived
This topic is now archived and is closed to further replies.