Change name of uploaded file to .ZIP and unpack

Created a plan in P2ATC - input start/dest and then autoplan. Validated and exported as msfs.pln file.

Attempt to LOAD pln in MSFS and it just CTD after pln is selected. Removed all mods and liveries added in Community folder - same result. Restarted MSFS and created the plan in sim - worked as expected.

I'm looking into this, but it will take awhile.  I'm on hour 2 of the 4+ hour update for MSFS to v1.9.3.0.  In the meantime, if you could email me the flight plan you exported from P2A, I can be sure and work with the same plan you had.  Email to [email protected].

Thanks,

Dave

Well, I finally finished the MSFS update and did a KPHX-KFLG FltPlan Export, loaded it into MSFS with no problem. I had the QUKY1-CARTL SID RW26 and the ILS RW21 with FLG transition at KFLG.  

It's possible you had a mismatch in the data levels that caused your flight plan to have a waypoint or procedure in it that MSFS didn't know about....or MSFS may have just decided to crash.

If you send me the flight plan that caused the problem, I can try it on my system to see what happens.

Dave

I tried the import again and was able to make it crash.  I will see If I can figure out what data is causing this.  I'm pretty certain it's one of the waypoints in the procedures.

Dave

Update:  I isolated  the problem and it will be fixed in the next update.  This should only happen with certain procedures that produce waypoints with no identifier, so it should be fairly rare.

Edited October 12, 20205 yr by Dave-Pilot2ATC

Thanx Dave. I sent you the plan anyway so you can compare.

Vic