Hello, I have a problem with the Lear 35A. After downloading and installing the latest version 4.3c into P3D V5 HF1, I can't start up the engines. I believe I'm doing everything as I was in V4.5 HF2, but it won't work. The following happens: After switching the GEN to START and adding fuel at 12 % N1, it further spools up, and at 20 %, the EGT jumps to 199, but that's it. The FAN speed indication stays at 0 the whole time. Any ideas are welcome - thanks!

7 hours ago, d.tsakiris said:

Hello, I have a problem with the Lear 35A.

If you haven't tried it, try clicking on Ready to Start on the Hanger popup (Shift + 1) just to make sure all switches are set as needed, and then go through the start procedure.

If that doesn't work, maybe try uninstalling and reinstalling the Lear.

Al

Edited December 6, 20205 yr by ark

Hi Al

12 hours ago, ark said:

try clicking on Ready to Start

That I tried. Sorry, didn't mention it. Made no difference. Yes, I guess I'll end up re-installing. Thanks

So, quick update: I de-installed both versions (4.2 from P3D V4.5 und 4.3 from V5), re-installed the latter, and now it works. I suspect it had something to do with the double installation and FSW's licensing not liking it...

57 minutes ago, d.tsakiris said:

So, quick update: I de-installed both versions (4.2 from P3D V4.5 und 4.3 from V5), re-installed the latter, and now it works. I suspect it had something to do with the double installation and FSW's licensing not liking it...

Good, glad to hear all is working.

Al