I think we nailed it,

If i disable Utlive2 everything works find, now I just need to understand how much time do I have to wait. 
 

This is good new’s, I have been working in this for a few months.

 

thanks
 

Pierre

2 hours ago, PierreFSX said:

I think we nailed it,

If i disable Utlive2 everything works find, now I just need to understand how much time do I have to wait. 
 

This is good new’s, I have been working in this for a few months.

 

thanks
 

Pierre

Thanks for feeback.

Could you grab a screenshot of UTLive when it pops-up whatever it is showing? Thanks

Yes no problem, is there an email I can use to send you the screen capture?

Pierre

I just email you at [email protected]

I also notice that I only get this message when I load MCE, so it seems that the message is triggered by MCE.

 

Thanks for your help

 

Pierre

I asked, on the UTLive 2 forum, what will trigger this message and they answer this:

"I am guessing that when you load MultiCrew you might be using a key combination ctrl+shft+12 or similar?  This is also a short cut for UTL settings within the sim.  See if you can configure MultiCrew to use a different shortcut."

are you using a key combination to load MCE?

Pierre 

Hi,

That was the issue, it seems that MCE is using ctrl+shft+f12 when it load's. I change the key combination ctrl+shft+f12 to ctrl+shft+f2 in UTLive2 (command to increase the IA traffic) and bingo I do not get the UTL message when MCE load. Now  I am getting one greeting from one ground coordinator.

Thanks for the support

Pierre

54 minutes ago, PierreFSX said:

Hi,

That was the issue, it seems that MCE is using ctrl+shft+f12 when it load's. I change the key combination ctrl+shft+f12 to ctrl+shft+f2 in UTLive2 (command to increase the IA traffic) and bingo I do not get the UTL message when MCE load. Now  I am getting one greeting from one ground coordinator.

Thanks for the support

Pierre

Excellent! Good to know about that. Never used UTLive