sudden problem

[Godwisper 0]

everything is fine till I climb up. Than it seems frequency does not change and remains same on both com1 and 2 so it goes in a loop with ATC asking for frequency change, it changes and moves to COM1 but than COM1 suddenly gets same frequency as COM2. Happened in the last 2 flights I did and even if I try a manual frequency change it goes back again to the previous. 

 

(using fs2020)

Edited August 20, 2021 by Godwisper

[Dave-Pilot2ATC 875]

Sounds like you don't have all the ATC "assist" features turned off in MSFS.

Dave

[pete_auau 1,163]

On 8/21/2021 at 6:04 AM, Godwisper said:

everything is fine till I climb up. Than it seems frequency does not change and remains same on both com1 and 2 so it goes in a loop with ATC asking for frequency change, it changes and moves to COM1 but than COM1 suddenly gets same frequency as COM2. Happened in the last 2 flights I did and even if I try a manual frequency change it goes back again to the previous. 

 

(using fs2020)

had  this  myself  found  out  had  the  ai  atc  still  ticked in  the  options  and  in the  assist  section  so checked  to see  if  you got  everything  turned  off   eg  ai  and  atc