September 22, 20214 yr I've had the throttle for a bout a week and spent a few hours trying to get it set up with little success. I loaded the QSOT profile, activated, etc. I just dont think its working even though I the profile confirmation active notice in P3D. For example, after I do this, the ailerons, elevator are mapped to the throttles themselves. I've even tried custom work in the bravo program but those don't seem to translate over either. All that I have gotten to work is by doing the mapping in P3d, which is time consuming and cumbersome. And I cant get things like reversers to work. Any ideas? One of the things I thought of is the path in the bravo program when you activate the PMDG profile.... what should that path be?
September 22, 20214 yr Its quite an envolved process when you start, you cannot just load a profile in the configurator and send it over There are several good youtube video that show you simhanger flight simulation has a good one that explains a lot In the drop downs of p3d do you have an option for the honeycomb inputs? In short you have to remove all the p3d inputs then if using pmdg aircraft there is an option to then send those to p3d first before then sending the actual profile for the aircraft You also have to make sure you have correct profile in the honeycomb configurator before hand and remember in p3d you have to select the bravo throttle quadrant in the controls section and beware of duplicate input between devices Your best option is trying to find the video i mentioned Sorry cannot post a link Edited September 22, 20214 yr by mazelda Pete Little
Archived
This topic is now archived and is closed to further replies.