Hi everyone,

I have a Mad Catz Pro Flight Cessna Yoke, and since update 8, I have been having problems saving the profile for any aircraft.

Because the Mad Catz Pro Flight Cessna Yoke has a short moment (4cm forward and 4cm aft) I use Extremity Dead Zone to control the amount of yoke/stick movement in the sim. After the update, I can set it to what I need and save it. However, if I close the sim and restart it, I always have  to reset Extremity Dead Zone.

When I look at the profile, and compare it to an old one, Extremity Dead Zone is missing. In the old profile it is referred to as AxisOutDeadZone. Here follows what I mean:-

Old profile;

<Axis AxisName="X" AxisSensitivy="19" AxisSensitivyMinus="19" AxisNeutral="0" AxisDeadZone="0" AxisOutDeadZone="9" AxisResponseRate="1050"/>

New profile;

<Axis AxisName="X" AxisSensitivy="0" AxisSensitivyMinus="0" AxisNeutral="0" AxisDeadZone="0"/>

Any ideas would be welcome, thank you in advance

Rich

 

Hi Rich,

The only thing that I can think of and you probably already did, would be to unplug the yoke and let MS2020 redetect it. And then try to rebuild your new profile again.

Mario 

Edited March 4, 20224 yr by Marioalberto

Hi Mario,

Yes I tried it......no it didn't work but thanks for the advice.

 

I am happy to report the current BETA has fixed this problem. The extremity dead zones will hold. On Xbox. And on a PC. Neither used to hold for me. Now it holds like it used to on PC and Xbox.