August 22, 20223 yr Hi all, every time I start MSFS, drone and external views initiate from the same position (behing the aircraft). Once I change point of view it stays during the flight but once I start MSFS next time again initial positions are reset and starts agaion in the position behind the aircratf. Any tip or idea how the initial position could be predefined or saved (either for the whole MSFS or at least for particular model/aircartf) ? Many thanks ! JM Jan Maca maca11 using PMDG 747 v3 P3D v 4.3
August 23, 20223 yr I don't think that is possible. See it as part of the flight preparation 🙂 The default pilot position, landing view etc. can be changed, however. Paul Schmidt We're fools to make war on our brothers in arms.
August 23, 20223 yr There's a command to reset the drone view back directly behind the plane. So on the hat that I use to move the drone, if I push the hat inward instead of moving it, then it returns to the default position. (It flies back quickly to the default position, does not just snap back the position). I use the same button to reset the drone, reset the external view,and reset the cockpit view. Same button resets no matter if I'm using cockpit, drone , or outside camera 5800X3D, RTX4070, 600 Watt, one or two 1440p 32" screens, 64 GB RAM, 4 TB PCle 3 NVMe, Warthog throttle, VKB NXT EVO stick, Honeycomb Alpha yoke, CH quad, 3 Logitech panels, 2 StreamDecks, Desktop Aviator Trim Panel. Crystal Light VR.
Archived
This topic is now archived and is closed to further replies.