February 16, 20242 yr 1 hour ago, Puukka said: The only two variables we were missing are one for the ASI Barber Pole, and the feedback variable of the Hydraulic Pump Switch. I assume you have a copy of the plane, so did you try searching for the needed variables? Al
February 16, 20242 yr Author Yes, sure, and I‘m using SPAD.next which shows the variables and events which are changing at the moment. Helped 99% except the two mentioned ones. So when switching the Hydraulic Pump switch it shows the mentioned variable sending a 3 at ON and a 3 at OFF, but not 1 ON and 0 OFF. No problem when there would be a change of another variable as the HYDRAULIC SWITCH, but that one stays at 1. Regarding the Barber Pole of the ASI we might haven‘t found the right variable name yet. Regards Edited February 16, 20242 yr by Puukka Herbert PuukkaX-Plane 12 - King Air C90, PA-46, Air Manager
February 17, 20242 yr 23 hours ago, Puukka said: Yes, sure, and I‘m using SPAD.next which shows the variables and events which are changing at the moment. Helped 99% except the two mentioned ones. So when switching the Hydraulic Pump switch it shows the mentioned variable sending a 3 at ON and a 3 at OFF, but not 1 ON and 0 OFF. No problem when there would be a change of another variable as the HYDRAULIC SWITCH, but that one stays at 1. Regarding the Barber Pole of the ASI we might haven‘t found the right variable name yet. Regards Did some searching. I see the Avar (A:AIRSPEED BARBER POLE, Knots) is being used in some animation code. Don't know if that is what you are looking for. As for the Hydraulic switch, it seems to use the K event HYDRAULIC_SWITCH_TOGGLE but with an index of 3. The associated boolean Avar is HYDRAULIC SWITCH:3 (also index of 3). This is the best I can tell you. If you need more information I suggest you contact the developer, Flysimware. Al Edited February 17, 20242 yr by ark
Archived
This topic is now archived and is closed to further replies.