GSX ignores cargo type selection

[BWBriscoe 122]

I've set all of my GSX EGLL gates to be Cargo Loader gates (no conveyor belts). I also set LGKR (corfu) gates to be cargo loaders so that it was realistic when arriving.

But, on requesting boarding at EGLL, up comes the conveyor belt. I reset GSX and check the gate and it says Cargo Loader but still sends a conveyor belt. Same thing happened in LGKR.

Can anyone help? Thanks

[virtuali 4,446]

you omitted the most inportant thing: the airplane used. If the airplane can’t use cargo loaders (for example because its cargo door is too low), GSX will use belt loaders, no matter what you set in the airport profile.

[BWBriscoe 122]

16 hours ago, virtuali said:

you omitted the most inportant thing: the airplane used. If the airplane can’t use cargo loaders (for example because its cargo door is too low), GSX will use belt loaders, no matter what you set in the airport profile.

It's the FBW A320 so is definitely high enough for cargo loaders.

[BrammyH 478]

Post deleted. I was wrong.

Edited May 13 by BrammyH

[Zangoose 1,639]

If the OP is on about the loaders that they use the containers for with the bags in then the A320 IRL can certainly support those.

Edited May 13 by Zangoose

[virtuali 4,446]

34 minutes ago, BWBriscoe said:

It's the FBW A320 so is definitely high enough for cargo loaders.

They are high enough for the FMC15 ULD loader, but of course, in order to see it, you must tell you want to use ULDs (AKH, the only kind allowed in an A320) in the airplane profile.

[BWBriscoe 122]

In both airport menus all the gates were set to Cargo Loader

[virtuali 4,446]

I said the airplane profile, that always takes precedence over the airport profile

[BWBriscoe 122]

On 5/13/2024 at 8:32 PM, virtuali said:

I said the airplane profile, that always takes precedence over the airport profile

Where do I change it in the airplane profile? It's clear in the airport parking menu, but can't see it on the 'Customize Airplane' settings.

[virtuali 4,446]

4 hours ago, BWBriscoe said:

Where do I change it in the airplane profile? It's clear in the airport parking menu, but can't see it on the 'Customize Airplane' settings.

You click it on a Cargo door, to indicate the loader type. GSX Manual. Paragraph "Cargo Doors options" at Page 64.

Edited May 15 by virtuali