And it was just a reverse of the original plan.
Originally - KONT - KLAS errors
KLAS - KONT no errors

On 11/23/2024 at 10:54 PM, Zatoichi said:

None of my flight plans work in direct import.

I've the same problem: created a Flight Plan in SimBrief, then tried to import it into Pilot2ATC, and it did not work.
For the very same plan, importing it into MSFS-2020 works and importing it to LittleNavmap works.

I am using Pilot2ATC v.3.0.0.0_EarlyAccess 0.0.27N (latest), with AIRAC version: Navigraph 2412 (latest).
P2A in two popup error boxes says "SID not found in AIRAC data" then "STAR not found in AIRAC data". Looking at the waypoints, I see that it has imported it OK.
Unchecking the button "Import Procedures" gets rid of the errors.
(In my testing, the state of the Settings > Flt Pln >"ATC Assigns SIDs" & "ATC Assigns STARs" had no bearing on the outcome.)

On a side note, in this particular example (short 43min flight at 5,000ft), to successfully Validate, I've had to enable the checkbox Flt Pln > Ignore Airway Altitude Restrictions.

SimBrief > Route
DCT DVR L10 RINTI B3 TRACA DCT RUBUT DCT

SimBrief > ATC Flight Plan
(FPL-N11SR-IS
-S22T/L-SDGRY/S
-EGKK0530
-N0175F050 DCT DVR L10 RINTI B3 TRACA DCT RUBUT DCT
-LFQT0044 LFPG
-PBN/B2 DOF/241218 REG/N11SR EET/LFFF0022 PER/A RMK/TCAS)

3 hours ago, SMap65 said:

<snip>
(In my testing, the state of the Settings > Flt Pln >"ATC Assigns SIDs" & "ATC Assigns STARs" had no bearing on the outcome.)
<snip>

I don't seem to be able to edit my previous post, hence the double post.
I did another test after a while and noticed that if I have the option "ATC Assigns STARs" then it adds another waypoint (MVC) which does not appear in SimBrief therefore, as advised, will have to keep it checked, at least for this route.