Hi ! After I finally succeed in updating pilot2atc, I have a DataMgr.Init Error message each time I launch the program with many lines indicating that something has gone wrong. What should I do now to repaire this issue ? Thanks 🙂 

---

email the error message to me at [email protected] and I can figure it out.

Dave

I'm also getting that msg. It will not connect to XPlane. Program crashes 

Try to run P2A as admin

 

15 hours ago, Lostania0 said:

Hi ! After I finally succeed in updating pilot2atc, I have a DataMgr.Init Error message each time I launch the program with many lines indicating that something has gone wrong. What should I do now to repaire this issue ? Thanks 🙂

Hi,

The error message you emailed me appears when the program can’t find the database or it has been corrupted or emptied.  The message just says that it can't find the ATCController table, but generally, the whole database file has no data at all.

To correct it, download and install the full version of P2A V3.

Then, instead of doing the old manual conversion, use the Navigraph Auto Update.

• Open the Data Mnt Utility
• Click on the Data Updater tab
• Click on the Navigraph Auto Update button
• When prompted, enter your Navigraph credentials and Allow P3A to access your data

 

The program will then download, convert and install the latest AIRAC cycle.  It takes a few minutes, but is all automated.

Dave