toxic_ger

Hey, maybe the same problem I have just flown on IVAO from EDDS to EDDP. At FL100 the Speed (the Magenta Speed thing, dont know the right word ) switched to 320 but the plane didn´t accelerate. After a few seconds (i was on FL 115) the Stall Warning appeared (180knots) the AP disconnected. All the time the Engines were on 90-95% N1. The Phys. Throttels were at ~55%. I used TO1 and CLB1. Real Weather (Active Sky) were used, the Wind came from behind with 32knt. While I was busy i turned the AP on at 3000~4000ft. Havent reached the 250knts mentionend in the Tutorial, could this cause the Problem? Greetings PS: sorry for bad english

Okay, I think i have missunderstood this. Thougt the default Value will override the outhers. Thanks to everyone. ^_^

The Question is, why is the TA 18000ft although in the downloaded Aircraft Settings the TA is 5000ft?

Didnt work. Possible its a problem with my Software Settings outside FSX. Installed the 777x and NGX again, Problem still exists. Removed Liverys and installed agian, Problem still exists. I loaded the AeroLogic Livery. The Aircraft Specific Settings contains the default TA 5000ft but you see in my posted Picture above the VNAV TA is still 18000ft. I Saved the "Panel State Short" where i have changed manually the Forcast and CLB TA. That works....

Maybe this helps.

Of course. But 18000ft still remains.

Hi, I Set manually the standart TA to 5000ft, but there is still the 18000ft TA at the Desc. Forcast page and at the CLB page. Have the same Problem with the NGX. So if anyone could help to solve this i would appreciate. (sry for bad english )

The lights are incredible. PMDG delivers a masterpiece, thanks.

You must go to the FSX Options and change the Metric System to the US Feet System.

Okay, Problem is gone after i changed the metric to us feet system in the fsx settings maybe one of the pfd dont like the metric? :)

Pitot Heat is on. Capt/Fo altimeter are synchronise.With and without an externel weatheraddon the problem is the same.Startet in EGKK with the exact settings from the Tutorial 1. 08R - CLNSP SID - CLN. The Altimeters show at the ground already 60ft (at the left pfd) and 180ft (at the right pfd) without setup the plane for the flight. Here is the Screenshot i made just after the alert illuminated.

Failures are not active.

Flying the Tutorialflight from EGKK to EHAM the second time and have the same problem with this "Alt Disagree" alert. From the QRH: The left PFD shows ~6300ft while the right PFD shows 20000ft. The plane climb sonly to FL 100-110 (because of this alert i think). Can someone help me with this problem? Sorry for my bad english.

not 1-1,5 hours flight time but very nice approaches. LOWI, LXGB, LFMN

+1, Austrian