rdtv

Yeah what is happening with SP2 for the NGX? Ryan Taylor

Removed.

Been using Prepar3d for the past few days now and is such an improvement. Got all my scenery and a certain 737 product ported across with the FSX2P3D tool and also downloaded the file from the Flight1 Forum for EZDOK to work in Prepar3d. When flying though at random times my EZDOK stops working and you can click through the cameras in the studio but they don't update in the simulator, it appears to look like this: Any thoughts? As it's really annoying and is ruining my flights. Thanks guys in advance.

I also had a freeze with 'Exit Hold' on the FMC but I also am getting freezes upon various phases of the flight (incl taxing) with no FMC Interaction, Patrick, you do seem correct all we have been flying is the -800 it seems, would be interesting to see if its similar results on the -900.

It happens with me at random phases of flight even when not touching the FMC (as others have stated) like during take off roll and landing and even taxiing at the holding point... Quite possibly, but its happening at so many airports it seems...

Similar problems reported with the aircraft control surfaces and virtual cockpit/ panel freeze here: http://forum.avsim.net/topic/341796-panel-and-airfraft-freeze/page__st__75

Nah I have no traffic addons installed.

I don't know it seems more like a payload issue with the NGX, the way they have the two class layout or single class, it's obvious not every airline carries 145 passengers and 145 isn't the capacity of the 737-800 so hrm

Ah 189 isn't too bad to be honest, it sounds worse than it is...

Yeah I've noticed it isn't mentioned in the intro doc etc...

Switching to external view didn't work for myself also.

Yeah would be good to actually get propper cabin layouts because 189 is a popular choice in Europe especially for low cost airlines squeezing the most out of their NG's. I haven't got the MD-11 but real time re-fueling would be rather cool.

Strangely I don't even have FSUIPC installed, it is a completely fresh install bar a couple of UK2000 Scenery airports, Aerosoft Palma, Ibiza & Menorca, Eiresim Alicante and GEX oh and obviously the NGX...

Anyone got any ideas on this? Quite annoying when using real load sheets not being able to simulate the real loads factor.

Just to confirm guys when you lose control (panel freeze) switch to the external model and although textures load okay and performance is fine as its still flying, if the aircraft was previously doing a turn the flight surfaces are physically 'frozen' on the external too so its the whole aircraft not just the virtual cockpit/ panel that is freezing as such.

Hey, It happens if the FMC is programmed with flightplans (I've flown around 4 flights with this now into various airports at various times and weather) and also during some touch and goes where I had only programmed in the ILS freq and was flying Circuits... - Interesting comment from ICMC, I close FS a few minutes after this occurs as I didn't realise it eventually works again... So I don't know what it could be as it doesn't seem to crash really as FS is still running and as ICMIC just said it starts working again?N.B. I don't have any auto-saving on my FSX enabled and its a complete fresh install of Win 7 64 Bit and FSX for the NGX.

Thanks for posting Majid I just flew a short 40min hop in the jet and all seemed to work well and performance good but it seems that 1 minute it can be all frozen as you describe above 5mins into my flight and other times runs fine and other times happens after I land, its very random and I don't know about you but I don't get it with any other a/c I have.Now tried it and had mixed results at various payware and freeware and default scenery in a variety of weather conditions and seems to happen randomly.

Yeah I've just messed about with it somewhat and it is somewhat perplexing, hopefully someone from PMDG can look at this issue...

Ahh yes that sounds interesting could quite well be as it does lock useage of the aircraft as such.

Yeah hopefully we can get this fixed.

it isn't so much the 2D freeze its the whole aircraft freezes with its control surfaces both internally and externally, all animations, everything. Whilst FSX continues to run which brings me to think it may be a PMDG module or some interaction with what is running the PMDG aircraft, really weird and yeah I rarely have issues with other PMDG aircraft myself or other payware, never seen this before.

More info at http://forum.avsim.net/topic/341796-panel-and-airfraft-freeze/ similar issues reported by myself and a few others (I've stuck all my stats on those posts as well). Lets hope we can get this fixed.

its to do with uiautomationcore , if you google you'll find more about it, easily fixed - I had the same issue when I first flew the NGX.

I'm getting the same issue.

Yeah my issue is really 'occassional' though hrm, weird the way it isn't freezing the full Flight Simulator or crashing as such but instead just the aircraft and its VC although its still flying.