jacklux

Each time I connect the GPU, the IA Copilot requests clearance. J

How can I delay contacting air traffic control for clearance? I want to be able to connect the ground power unit and make the necessary adjustments before requesting clearance from ATC, and therefore not contact ATC as soon as the ground power unit is connected. Is there a way to do that in the settings? Thank you very much for your help. J

Hello all, I intend to buy the FlightFX Piaggio F180 for MSFS 2020. I am wondering if the aircraft has an autothrottle option and if there is a way to avoid using the MFS (perhaps by using an alternative configuration). Thank you for your help. Regards, J

Good morning, I have an issue with the CIRRUS Vision Jet (MSFS 2020) autothrottle system. When ready to take off, I can't activate the autothrottle buttons by clicking on them while on the ground, so to be ready to activate autothrottle when in the air using the AP button, which also does not work; it only works if I click on it several times or use FLOW Pro. That's also the case with the AP button. Any idea what's happening? Ty Regards

Thank you very much. Will try. Regards; J

Hello, I mapped a button for my joystick in the MSFS 2020 settings for the Cirrus Visiojet 50 autopilot, but it doesn't work. I did the same for FLOW PRO, but it doesn't work either. Thank you for your advice. Regards, J

Thank you very much. J

Morning to all, I intend to buy a new HOTAS and hesitate between several, especially LOGITECH X 52 pro or LOGITECH X56. But open-minded to other HOTAS :) Advices would be appreciated. Regards, J

thank you was the rudder 🙂 Regards,

Thank you, but the rudder trim is automatic in the settings. Will see. ty J

Hi, My Kodial 100 is always titled to the left. The loading is correct and balanced. Any idea? ty in advance. Regards, J

CLOSED I used the the 2024 instead of the 2020 files. TY

Hi Guys, I just subscribed to a premium license for PMS50 GTN750 that I installed in the community folder to use with the SIERRA C24R. The license activation has been done. I load a flight plan into the plane from the world option, and the ATC gives me the flight authorization. However, I do not see the flight plan in the Garmin. I tried to import it from Simbrief with the ad hoc option, but Garmin told me there was no valid flight plan. It is the same with the import option from the catalogue. Thank you for your help. Regards,

Ty, I followed your answer using ctrl E, and now the engine is running. Thank you so much

When the GPU is connected amps are full +40. When I disconnect the GPU amps are minus 40 Any Idea? Ty in advance. J