First I'd like to thank you for such a great product. But my problem is, I've had FS2Crew for a few years now, and I've always had the same ZFW 245.000 lbs.Now I've been searching around the forums, and I understand that it reads the loads via the SDK. I read the manual, and it said to makesure the payload was =-1 or 1 or something.I always start my 767 up from cold and dark (the parked at KSEA situation file), but my question is where can I check to see that the payload is =1?Where can I find the CFG, or whatever file it is that contains this? I literally spent half an hour trying to find where to change this, but no joy.Thanks in advance!

First I'd like to thank you for such a great product. But my problem is, I've had FS2Crew for a few years now, and I've always had the same ZFW 245.000 lbs.Now I've been searching around the forums, and I understand that it reads the loads via the SDK. I read the manual, and it said to makesure the payload was =-1 or 1 or something.I always start my 767 up from cold and dark (the parked at KSEA situation file), but my question is where can I check to see that the payload is =1?Where can I find the CFG, or whatever file it is that contains this? I literally spent half an hour trying to find where to change this, but no joy.Thanks in advance!

Hi,Payload = 1?Correct me if I'm wrong, but does it say that in the FS2Crew 767 manual? I don't recall ever writing that.Please send me the page # so I can look it up.Cheers,Bryan

Sorry I was in a rush when I was typing this, but in the manual it says [payload.0]Payloadlist=-1There we go, I did it off memory sorry for the confusion the first time :(Unless I'm super blind and its in the aircraft.cfg?Edit: I do also think it is the situation file. When I loaded the tutorial flight from SFO-LAX, I got the correct pax # and weights that was entered into the load.