Jump to content

Archived

This topic is now archived and is closed to further replies.

Jack0913

PMDG MD 11

Recommended Posts

I'm having a problem in that I lose the FSX ATC window after engine start. What I have been doing is going through the preflight and not fast forwading the FS2Crew but after engine start no FSX ATC window.At the moment I'm taking off, then during the climb I save the flight close the sim down and then restart as a saved flight. I also have to get the flight plan sorted before an unevental flight.Have recently upgraded to four Gig of RAM to overcome this probem but not the answer I'm looking for.Help pleaseJack

Share this post


Link to post
Share on other sites
I'm having a problem in that I lose the FSX ATC window after engine start. What I have been doing is going through the preflight and not fast forwading the FS2Crew but after engine start no FSX ATC window.At the moment I'm taking off, then during the climb I save the flight close the sim down and then restart as a saved flight. I also have to get the flight plan sorted before an unevental flight.Have recently upgraded to four Gig of RAM to overcome this probem but not the answer I'm looking for.Help pleaseJack
Hi Jack,That's a consequence of the way FS2Crew gets the pushback tug to stay 'connected' to the nosewheel. Are you doing the pushback procedure in full?Make sure the pushback procedure is completed.Also, ensure you installed all FS2Crew updates.Best,

Share this post


Link to post
Share on other sites

Interesting to know. I've had this problem as well and didn't even think it would be related to FS2Crew. Any suggestions to those of us who use AES, or will we need to use the integrated pushback, and then properly disconnect to get the ATC window back?


Eric Szczesniak

Share this post


Link to post
Share on other sites
Interesting to know. I've had this problem as well and didn't even think it would be related to FS2Crew. Any suggestions to those of us who use AES, or will we need to use the integrated pushback, and then properly disconnect to get the ATC window back?
Set pushback required to 'No' if using AES via the Config Panel.Best,

Share this post


Link to post
Share on other sites
I'm having a problem in that I lose the FSX ATC window after engine start. What I have been doing is going through the preflight and not fast forwading the FS2Crew but after engine start no FSX ATC window.At the moment I'm taking off, then during the climb I save the flight close the sim down and then restart as a saved flight. I also have to get the flight plan sorted before an unevental flight.Have recently upgraded to four Gig of RAM to overcome this probem but not the answer I'm looking for.Help pleaseJack

Share this post


Link to post
Share on other sites

  • Tom Allensworth,
    Founder of AVSIM Online


  • Flight Simulation's Premier Resource!

    AVSIM is a free service to the flight simulation community. AVSIM is staffed completely by volunteers and all funds donated to AVSIM go directly back to supporting the community. Your donation here helps to pay our bandwidth costs, emergency funding, and other general costs that crop up from time to time. Thank you for your support!

    Click here for more information and to see all donations year to date.
  • Donation Goals

    AVSIM's 2020 Fundraising Goal

    Donate to our annual general fundraising goal. This donation keeps our doors open and providing you service 24 x 7 x 365. Your donation here helps to pay our bandwidth costs, emergency funding, and other general costs that crop up from time to time. We reset this goal every new year for the following year's goal.


    18%
    $4,720.00 of $25,000.00 Donate Now
×
×
  • Create New...