December 2, 201015 yr Hi all!I have a question regarding the engine start of the Overland A3XX series. I noticed when starting the engines they go to almost 100% N1 and then slowly back to normal values. I have tried looking to the aircraft.cfg file, a3xx.air file, but could not find any setting to adjust this. Any clues?Thanks in advance!Erik
December 3, 201015 yr Do you have the throttles open altogether? I started up mine and it started up fine. Dave. "It goes without saying that when survival is threatened, struggles erupt between peoples, and unfortunate wars between nations result." -HIDEKI TOJO
December 3, 201015 yr Author Throttles are set to idle, but I think what went wrong. I used the Project Airbus model and Ken Mitchell panel, and there were no issues. Just press engine starter and start engine. With the Overland model this caused the issue above. However after waiting about 20% N2 and then starting the engine everything is OK. My mistake
December 3, 201015 yr Hi all!I have a question regarding the engine start of the Overland A3XX series. I noticed when starting the engines they go to almost 100% N1 and then slowly back to normal values. I have tried looking to the aircraft.cfg file, a3xx.air file, but could not find any setting to adjust this. Any clues?Thanks in advance!ErikWhat program is used to look at or edit an air file? Best Regards, Vaughan Martell PP-ASEL KDTW
December 3, 201015 yr Author What program is used to look at or edit an air file?I use AirEd (try via google) to look into an air file.
December 3, 201015 yr Erik,Thank you for the information.I do not want to actually edit a file but have always wanted to see the data and format / content.Have a good day. Best Regards, Vaughan Martell PP-ASEL KDTW
Create an account or sign in to comment