May 30, 201115 yr After I run through the Runway Entry Proceedure and position on the runway, the Mode turns to Rejected T/O in red. What am I missing?Thanks
May 30, 201115 yr Have you actually put the autobrake in RTO mode in preparation for the take off?Al Alan Bradbury Check out my youtube flight sim videos: Here
May 30, 201115 yr Author The FO usually does that at +25 in the Pre-flight. Have you actually put the autobrake in RTO mode in preparation for the take off?AlI'll give a run-through to check if it is missing that proceedure, or if I manually changed the setting.
May 30, 201115 yr Author OK, FO set autobrakes to RTO (should they stay there for T/O? I noticed the FO turns them to Off later in Initial Climb). After Runway Entry Proceedure, the Mode went to Takeoff, but then immediately jumped to Reject T/O. I could not scroll backward through the modes, but I scrolled forward through all the modes until it return to Takeoff, then everything worked except the cabin announcements which had jumped to the landing announcement. The FO usually does that at +25 in the Pre-flight.I'll give a run-through to check if it is missing that proceedure, or if I manually changed the setting.
May 31, 201115 yr Commercial Member After I run through the Runway Entry Proceedure and position on the runway, the Mode turns to Rejected T/O in red. What am I missing?ThanksHi,Please look at Appendix A in the manual.The speech recognition system is somehow hearing the 'trigger word' for RTO mode, which is "Stop".If it hears "Stop", it will put FS2Crew into Rejected Takeoff Mode.Please check your CVR log (link is the manual) to see if the system is somehow hearing a "Stop" voice command.Cheers, B. York FS2Crew Web Site / FS2Crew Facebook Page / FS2Crew Discord
May 31, 201115 yr Author You are correct ... the log shows "stop" immediately after "runway entry procedure". I have no clue where that is coming from. To my knowledge I am not saying anything or pushing any buttons until "takeoff". I'll try again. Hi,Please look at Appendix A in the manual.The speech recognition system is somehow hearing the 'trigger word' for RTO mode, which is "Stop".If it hears "Stop", it will put FS2Crew into Rejected Takeoff Mode.Please check your CVR log (link is the manual) to see if the system is somehow hearing a "Stop" voice command.Cheers,
May 31, 201115 yr Author OK, must have been pilot error. I ran through the procedures without any problems. I just need to be careful of what I say when I'm ready for takeoff. I'm sure the FO is bothering me and I tell him "Stop!"
Create an account or sign in to comment