Jump to content

Archived

This topic is now archived and is closed to further replies.

captainklm

engine 1 not workig

Recommended Posts

im starting to lose my patiance,after starting the engine when I push the throttle forwards only engine 2 goes and engine 1 is stuck on idle. Im really maddoes anyone else have this problem?

Share this post


Link to post
Share on other sites

Are both trottle levers moving? If not I think you may want to push E+ 1 Then 2 While holding E.

Share this post


Link to post
Share on other sites

im using a saitek throttle quadrent, yes the levers are moving in the NGX but it stays on 20N1. I think the A/T was on. Is that a problem?

Share this post


Link to post
Share on other sites

i have had this issue using fsuipc and autothrottles, i dont use fsuipc anymore for calibrating my ch throttle

Share this post


Link to post
Share on other sites
i have had this issue using fsuipc and autothrottles, i dont use fsuipc anymore for calibrating my ch throttle
Good choice.

Share this post


Link to post
Share on other sites

Sometimes I have the same Problem.Saitek TQ, NGX-RTM, controlled by FSUIPC.It only appears, when starting from cold and dark panel state.As a workaround, I just Press the approbiate keyboard key for raising throttle, and suddently the leaver from the TQ works again.Don't know what the problem is.

Share this post


Link to post
Share on other sites

×
×
  • Create New...