Hello folks,I've just recantly purchased Saitek yoke, rudder and two throttles. I have also purchased FSUIPC.I was just curious to know what assignments you guys are using for your levers buttons and switches etc... for the NGX, If you've got the time to list them.Just looking for ideas.Richie

_{Saitek Yoke:Buttons mapped via FSUIPC, control axis not mapped via FSUIPC.Left trigger button = brakesLeft up/down button = trim up/downLeft hat = viewsRight thumb button (red) = AP disengageRight up/down button: Up=overhead panel toggle, Down=VC pedestal view (buttom commands "A" press).Right left/right button: Left=Radio stack/rear pedestal, Right=FMC toggle (button commands "shift+#" for the FMC toggle)This is the layout I use for most jet aircraft, PMDG 73/74, Concorde, LDS767, etc.I gave up on the saitek throttles...POS IMHO. Bought a CH 7 lever throttle, it's cheap but does the job. Also has buttons on the throttle mapped via to TOGA, Fuel cutoff toggle, AT arm/disarm, gear up/down, dome light, couple others I can't recall.Hope this helps,Rob.}

I gave up on the saitek throttles...POS IMHO.

I have 2 of them for a year now and they have worked flawlessly. With 2 of them you have 20 extra buttons to assign and the combinations are endless.

Hi,I also have the Saitek yoke and two throttles: here are my assignements:Left trigger button: brakesLeft up/down: zoomHat: head movement in VCRight up/down: cycle through viewsRight left/right: unassigned for now, will be used for FS2Crew button edition, for green and red buttonsRight red button: Auto pilot disengageFor the throttle axis, from left to right:- Spoilers- Throttle engine 1- throttle engine 2- reverse (for both engines)- Gear- FlapsThrottle buttons: the upper row is assigned to lights (followed the order of the cockpit) and on the lower row, I have parking brakes, TO/GA and A/T disengage.Using just the Saitek software, everything works like a charm.Merry Christmas to all!Fabrice