January 15, 201214 yr I had hoped to get rev thrusters activated by assigning the F2 key to a switch on my CH USB Yoke using FSUIPC but for some reason it just doesn't work. It seemed to some time ago, but no more despite reprogramming. I noticed there is a 'reverse' checkbox in the FSUIPC throttle calibration routine. Is there an effective way of using this or something else to get reliable rev thrust?Thanks in advance!Noel Noel System: 9900X3D Noctua NH-D15 G2, MSI Pro 650-P WiFi, G.SKILL 64GB (2 x 32GB) 288-Pin PC RAM DDR5 6000, WD NVMe 2Tb x 1, Sabrent NVMe 2Tb x 1, RTX 4090 FE, Corsair RM1000W PSU, Win11 Home, LG Ultra Curved Gsync Ultimate 3440x1440, Phanteks Enthoo Pro Case, TCA Boeing Edition Yoke & TQ, Cessna Trim Wheel, RTSS Framerate Limiter w/ Front Edge Sync. Aircraft used in MSFS 2024: Fenix A320, Aerosoft CRJ, FBW, WT 787X, I-Fly 737 MAX 8, Citation Longitude.
January 15, 201214 yr I have it assigned to my CH yoke on 'Button2', but I didnt use FSUIPC. I just assigned it in the FSX Settings/Controls. I set the 'Repeat' slider to the right so I only have to push the button once to get full reverse thrust. Edited January 15, 201214 yr by PIC007 Jay
March 6, 201214 yr I have my assigned under (FSUIPC) "Throttle Decr", then under "Control to repeat while held", check that box. Under "Control sent when button release" put "Throttle Cut"
Create an account or sign in to comment