When running through prechecklist I have my engine cut-off and parking brakes set, but my PF asks me if I'm sure of both items. YES, I have the right settings so there must be a bug here somewhere.

When running through prechecklist I have my engine cut-off and parking brakes set, but my PF asks me if I'm sure of both items. YES, I have the right settings so there must be a bug here somewhere.

Hi,Did fsx ask you if you trust the fs2crew gauges ? If not, start in a default aircraft then switch to the ngx and when the popups appear click yes and all should be fine.

When running through prechecklist I have my engine cut-off and parking brakes set, but my PF asks me if I'm sure of both items. YES, I have the right settings so there must be a bug here somewhere.

Are you using external hardware or anything that might send a signal externally regarding the position of the fuel levers?That can run interference.Best,

FS2Crew gauges are trusted and no external hardware here other than yoke, pedals and throttle quadrant.

FS2Crew gauges are trusted and no external hardware here other than yoke, pedals and throttle quadrant.

That's the source there.One of my beta testers, who had the same issue, said this:"I use a panel state save and every now and then the PFC driver does not always load cleanly, if I cycle them with my go flight controls it gets them in sync. For some reason the positions are not necessarily correct all the time depending on where the switch position is when I shut the sim down. I then am making sure they agree in the sim with my hardware when I start up again. All I know is it solves the issues and all calls are correct."