Hi,still learning but when would the PNF accept the "Flaps Up Speed" after takeoff when i have the NADP2 activated (1500 reduction and 1500 acceleration height) ?. I sometimes have to say it twice. First time he do repeat the command but not the action.ThanksMichael

Hi Michael,You have to turn the speed knob one click first to update the speed to V2 + 20.This is fixed in SP1.Cheers,

Thanks :-)/MichaelPS!The packs on second run is not set to OFF during his before start procedures

He turns off the packs as part of his engine start procedure, not before start procedure.Cheers,

He turns off the packs as part of his engine start procedure, not before start procedure.Cheers,

HMM but after i say "start engine number 2" he did not move the packs off. There is where i noticed it as the N2 would not raise above 10-12%Remember this is on the second flight. Not the First one (which i did not secure)/Michael Moe

What was your Power Source set on the FS2Crew Config Panel?On the 1st leg, did you let the FO perform his shutdown flow or did you skip over it? You need to let the FO perform his main shutdown flow.And on the 2nd leg did the FO say "Starting Number One"?Cheers,

 

What was your Power Source set on the FS2Crew Config Panel?On the 1st leg, did you let the FO perform his shutdown flow or did you skip over it? You need to let the FO perform his main shutdown flow.And on the 2nd leg did the FO say "Starting Number One"?Cheers,

He did say Starting Number two and i did the "shutdown" on first leg but was being interrupted by crew so we had to start again./Michael