Hello there,

 

yesterday I was trying to figure out a "ready to taxi" startup state with fs2crew.

From what I've seen it seems that it starts with the before taxi checklist, and then we follow the normal procedures. Is this correct?

 

Regarding the aircraft, I'm usign the "ready to taxi" config state of the atr. Once the aircraft is loaded, I set up the FMC as required, perform the pushback and then start fs2crew and go through the before taxi checklist.

What else should be set on the aircraft before firing the before taxi checklist?

 

Thanks in advance

Hi Stefano,

 

That's correct.

 

Prior to the Before Taxi checklist, just ensure the aircraft is totally setup.

 

Cheers,