I am having an intermittant problem with the mouse controlling the knobs and switches while in virtual cockpit view in 737NGX. It works when I initially enter the cockpit but after scrolling around the cockpit with the hat on my joystick and using the pull down menues I am unable to use the mouse. I'm not really sure what causes it, but it has happened numerous times. If I switch to 2D pilot or 3D co-pilot it works, but will not work again in Pilots view 3D.

 

I'm running an Nvidia card with the latest drivers, 8 GB Ram, Windows 7, 64 bit

Try changing the zoom or moving seat position. This never happened to me in the NGX, but when I had the same problem in the Classics hangar fw-190, that helped.

Are you using EZCA ? If so, then it sounds like you may have your view point "looking" through the pilot's seat. In which case, you will then be unable to use the mouse click spots in the VC. As per the previous reply, try adjusting your position.

 

Regards

 

Gary

Might be dumb to say, but also check that you didn't inadvertently enable Mouse Yoke. Right click->mouse yoke. I don't use my hat to move around the VC. I use spacebar and the mouse.

Thanks for the input. I found the problem to be I had my seat too far back.

 

 

Might be dumb to say, but also check that you didn't inadvertently enable Mouse Yoke. Right click->mouse yoke. I don't use my hat to move around the VC. I use spacebar and the mouse.

Good to know. Some of these little things are totally out of the blue.