I have these coast lines/Beach .

 

Although I have UTX Installed, I have unchecked everthing. And I still get this. Any ideas?

 

Its right next to KSEA in Orbx PNW area

 

Manny

global warming..!

nm

Boy - I can tell you're p****d!!

 

OK - Do you have any of the old PDX installed - the FZ02 conversion, I mean? I think it was FL915150 that causes the shoreline changes... I'll do some more digging...

 

pj

 

Edit:

 

These files listed below might be still hanging around..

 

HL915150_FZ02_EX .bgl

HP915150_FZ02_EX .bgl

RD915150_FZ02_EX .bgl

RR915150_FZ02_EX.bgl

ST915150_FZ02_EX.bgl

 

915150mesh06.bgl

915150mesh07.bgl

915150mesh08.bgl

915150mesh09.bgl

915150mesh010.bgl

Manny, I'm sure someone has had this issue over in the registered Orbx forums. I'm betting you could find a thread relating to this without much searching.

 

There is an issue when using the ported PDX with UTX/Orbx. I can't find much else about it, though.

Yes I do. I have pdx installed.

It's UTX that's the problem, I think, Manny - I came across this:-

 

If you have installed UT upgrade, all the files listed below should have been renamed from .bgl to .ori

 

HL915150_FZ02_EX .bgl

HP915150_FZ02_EX .bgl

RD915150_FZ02_EX .bgl

RR915150_FZ02_EX.bgl

ST915150_FZ02_EX.bgl

 

They were the files listed in the earlier post.

 

Edit #2:-

"The fix for the shorelines appears to be achieved by renaming the HP915150_FZ02_PA.bgl."

- taken from one of my posts while playing with PDX..

thanks Paul