Hi

 

My question is about panel.cfg modification.

I'am using only VC, from obvious reason some area of overhead panel is not so clear, so without zooming or view point change operating is a bit tricky.

I'am using "A" button to change view point.

Using "A" button will switch view to F/O, then to upper overhead and then to lower overhead, so i must jump through these views.

How to modify panel.cfg to skip first two steps and have settings that after using "A" button once i will have lower overhead view ?

 

I was also considering to remove panel cfg entries and textures of 2D panels, will i get better performance by removing of those ?

 

If you can afford it try Ezdok software to change views - http://www.simforums.com/forums/ezdok-software_forum39.html

Yes, that is an option, but i think it is possible to resolve my issue without extra software.

It is possible, however I can not give you direct instructions based on NGX panel.cfg... 

 

Just make sure stuff is numbered correctly when you try and delete something from the .cfg. Also, KEEP A BACKUP!