goodday,

I use Fs2Crew with FS9.

 

I have following issue with the B737-800 (not with the 737-700):

 

During the start-up flow and landing-flow the startswitches are not going automatically to "cont"

No problem to do that manually, but I noticed this only. and the pilot/co-pilot still saying "auto" ofcourse.

 

is this a bug in the program or is this something else I missed...?

Do you have the latest update installed?

 

FS2Crew might be thinking you're running a BBJ model...

Hello,

Yes I have the latest update.

but I have this since the beginning and I have never used a BBJ model. only the 737-700 WL and the 737-800 WL (both widescreen)

just forgotten.

Even after a re-install (several times) it does not change

Hello,

 

that's strange. I never used a BBJ model. Only the 737-700 WL and 737-800 WL (both wide screen)

and yes, I have the latest update, but the problem is there from the first day/install beginning. (long time ago)

 

I had several times try a re-install but no change.

And as already mentioned, it's only by the 737-800

Hi I have the same problem which is the possible solution? thanks

Do you have the latest update installed?

 

FS2Crew might be thinking you're running a BBJ model...

With the model BBJ if it seems to work is the 737-800 not working

I'll check into it.

 

Cheers,

I'll check into it.

 

Cheers,

ok I hope the answer

Hello any solutions? I have found that the F/O did no turn CONT position but then if the position turns self sorry for my english

I think it's a bug that affects that particular model (the 800).

 

I'll fix it in a future service update.

ok thanks

Hello Bryan

 

I have the same problem only on model 800 and also only on this model, when I put (for ex) 6.0 on Stab Trim, in Chekck list "Before Take Off", the captain say always : 9.0 unit !

 

Thanks for the future service update

 

Jean-François