I have a problem with the Beechcraft Duke B60 v2 in P3D v2.3. I am well aware that this aircraft is not "P3D native", but I think that others use it in P3D? Anyway, the rudder is hard over to the right on start up, and I can't seem to correct it. None of my other planes suffer from this, so it must be an issue specific to the Duke. Can anyone help?

I have the B60 V2 installed in P3Dv2, and everything works fine. I certainly have not noticed the rudder hard to the right problem you mention. I installed my Duke with the Estonia Migration Tool - THE LATEST RELEASE.  This release fixes some problems with the RealAir Duke noticed previously. But I have never seen mention of this rudder problem. If  you don't have the latest release of the EMT, I suggest you get it.  It is free if you have already purchased the EMT.

Yes, I have the latest version of the EMT that is compatible with P3D v2.3. It's just possible that I have a corrupted save file, so I will check that out.

Had same problem as you with rudder,

Turned out to be a conflict between prepar3d and fsuipc

Just makexsure you have not got same boxes ticked in both prograns

Like rudder in fsuipc and rudder in prepar3d

Mhazy

What do you mean by "the same boxes"?

I just went thru an FSUIPC setup in P3D v2.3. The first trick/step is to disable your built in P3D controls in the top left of the Controls page. Then start configuring FSUIPC for all of you controls and switches. Allow at least an hour. It can be done without reading the instructions but that depends upon your patience with fiddling.

 

I never had any B60 V2 issues but did have toe brake calibration problems. FSUIPC fixed them. Different people/PC have odd control issues and FSUIPC may be the only answer.

I deleted FSUIPC as a temporary measure, and the Duke is fine now. I will reinstall FSUIPC at some point, and see if the "glitch" has vanished.