Sign in to follow this  
longrangecruise

DISPLAY SELECT PNL

Recommended Posts

Hi,

 

After the F/O starts the Descent flow I am getting an EICAS DISPLAY SELECT PNL failure being on the paper checklist. With ECL selected I am getting the same, but in addition the MFD Checklist window pops-up and stays open (being in the way e.g. over the ND if looking straight out for landing).

 

Regards

Perry

Share this post


Link to post
Share on other sites
Help AVSIM continue to serve you!
Please donate today!

Try clearing all your PMDG system failures.

 

Make sure you follow the tutorial closely.

Share this post


Link to post
Share on other sites

HELLO?

I HAVE THE SAME PROBLEME

if i select electronic the windows of the display freeze until the end of the flight and i have no more control on it

if i select paper cfg., the window becomes black after the take off, and i have no more control on it

Share this post


Link to post
Share on other sites

Still the same problem when F/O runs the descent flow.

Tried clearing failures, but there were no active failures displayed in the PMDG submenu. (Followed the tutorial. )

Share this post


Link to post
Share on other sites

thank you! :P


 


"On CDU MENU where you can select FMC, PMDG SETUP, etc., you probably have DSP CTL set to ON.  The CDU is controlling the display. Select OFF and you should be back to normal.  See also FCOM 10.10.64" 


 


 


what is FCOM 10.10.64,.?


Share this post


Link to post
Share on other sites

Thanks!

I made sure that the F/O's CDU is on some FMS page and now it's resolved.

Still have to check ECL version.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this