Hi,

 

After the F/O starts the Descent flow I am getting an EICAS DISPLAY SELECT PNL failure being on the paper checklist. With ECL selected I am getting the same, but in addition the MFD Checklist window pops-up and stays open (being in the way e.g. over the ND if looking straight out for landing).

 

Regards

Perry

Try clearing all your PMDG system failures.

 

Make sure you follow the tutorial closely.

HELLO?

I HAVE THE SAME PROBLEME

if i select electronic the windows of the display freeze until the end of the flight and i have no more control on it

if i select paper cfg., the window becomes black after the take off, and i have no more control on it

Still the same problem when F/O runs the descent flow.

Tried clearing failures, but there were no active failures displayed in the PMDG submenu. (Followed the tutorial. )

Please see this thread:

 

http://forum.avsim.net/topic/420577-display-select-pnl/

 

 

Note this remark... see if it helps:

 

On CDU MENU where you can select FMC, PMDG SETUP, etc., you probably have DSP CTL set to ON.  The CDU is controlling the display. Select OFF and you should be back to normal.  See also FCOM 10.10.64

 

thank you!

 

"On CDU MENU where you can select FMC, PMDG SETUP, etc., you probably have DSP CTL set to ON.  The CDU is controlling the display. Select OFF and you should be back to normal.  See also FCOM 10.10.64" 

 

 

what is FCOM 10.10.64,.?

Thanks!

I made sure that the F/O's CDU is on some FMS page and now it's resolved.

Still have to check ECL version.

Same for ECL works fine!