I was flying the PMDG 737 NG in P3D V2.4 and after a while  30 min or so, the aircraft does not respond to my elevator or my aileron movement from my yoke. (Saitek).

 

I was not on AP. I was flying manual and juust a moment ago it was fine.

 

I then loaded another GA Aircraft but that did not change anything.

 

I went to the controls to see if my X-Axis and Y-Axis was erased but it did not.. It was there.

 

All the buttons were working from the Yoke.. so its not a connect issue.

 

Any ideas why this could happen? How do I debug the issue to figure out the offending item including user error?

 

 

using windows 8.1?

USB ports overloaded? I've been running into this issue , my CH throttle stopped responding, my Saitek pedals get stuck in one spot (rudder )

 

I've plugged them into a powered usb hub and haven't noticed an issue since.

 

 

using windows 8.1?

No Windows 7.

 

I've plugged them into a powered usb hub

 

I am using Powered HUB. Maybe I need to replace it? 

 

After installing the 737NG I rebooted and since then this has not happened again. Lets see..if it happens again. I';ll try changing the powered HUB to see if that would do it

 

Thanks guys