July 18, 201510 yr i have just downloaded NGX reboot and installed after un installing previous legacy version from control panel. however after pressing the enable button on the new configuration it says it detects the old version on my ngx panel cfg.and because of this i have to now reinstall the pmdg ngx which is really annoying as you might imagine. i did not see any info regarding procedure before installing the latest version surely this should not happen.. any help would be appreciated thanks. regards ,graeme. regards, graeme crawford
July 18, 201510 yr Hi Graeme, While it is a bit of an inconvenience, it's not as bad as it sounds. There's basically two ways of getting a clean panel config again. 1. Reinstall the NGX you do not need to uninstall the NGX first, just reinstall over the top (If you do this, open the PMDG Operations center afterwards and make sure you press the button to 'relink' your liveries. Then install NGX Reboot. Or... 2. Open the correct panel config and remove the FS2Crew entires then install NGX Reboot. If you have any problems, post a reply and I'll talk you through it. Little bit more info here http://forum.avsim.net/topic/471658-get-your-ngx-ready/ Neil Andrews. Fight or Flight - YouTube | Twitter
July 18, 201510 yr 2. Open the correct panel config and remove the FS2Crew entires then install NGX Reboot. I didn't have to do that when I just did the repair option, all the fs2crew entries were gone when I checked the panel cfg after the repair option. I7-8700k,Corsair h1101 cooler ,Asus Strix Gaming Intel Z370 S11 motherboard, Corsair 32gb ramDD4,, gtx 1080ti Card, RM850 power supply Peter kelberg
July 18, 201510 yr Look for the word right before the part you quoted pete Neil Andrews. Fight or Flight - YouTube | Twitter
July 18, 201510 yr Look for the word right before the part you quoted pete Yep late night here Btw great vid you done on the reboot I7-8700k,Corsair h1101 cooler ,Asus Strix Gaming Intel Z370 S11 motherboard, Corsair 32gb ramDD4,, gtx 1080ti Card, RM850 power supply Peter kelberg
July 18, 201510 yr Author Hi Graeme, While it is a bit of an inconvenience, it's not as bad as it sounds. There's basically two ways of getting a clean panel config again. 1. Reinstall the NGX you do not need to uninstall the NGX first, just reinstall over the top (If you do this, open the PMDG Operations center afterwards and make sure you press the button to 'relink' your liveries. Then install NGX Reboot. Or... 2. Open the correct panel config and remove the FS2Crew entires then install NGX Reboot. If you have any problems, post a reply and I'll talk you through it. Little bit more info here http://forum.avsim.net/topic/471658-get-your-ngx-ready/ option 1 worked ok thanks for your help. all working fine now Neil, and also thanks for the video. best regards, graeme. regards, graeme crawford
Create an account or sign in to comment