October 2, 201510 yr I'm running p3d v3 vanilla clean install on Win 10 x64 with the usb Ch Flight yoke and pedals + ch manager installed as well.. When i goto controls in p3d, i dont see the usual "ch flight yoke" (it does show up as ch flight yoke in control panel, devices, game controllers).. Instead I see "Control Manager ID #00 1" and "Control Manager ID #00 2".. If i goto the axes and try to set things (as they dont work out of the box), some things work, like setting ailerons, but others like pedals, toe brakes left and right dont work right, the assignments only show one axis, not two independents.. If i run calibration within ch manager things seem ok. Anyone else ran into this? Thanks in advance Asus Strix z790-e; 1000 watt evga SuperNova Plat; 14900k AC_LL 0.55 adp -0.050 253/253/355 CEPoff (CB-1pass 39200 80c, msfs peak 92,avg 60-78c, astrorender 95c,room76F); 64GB(dual 32) cl32 6400 at 6400 xmpII F5-6400J3239G32GX2-TZ5RK, Asus Ryuo III 360mm; Thermaltake v51 Case; Gigabyte 4090 OC; VR-Crystal; Dofreality H6; Astrosite
October 2, 201510 yr Yes. Having problems controlling flaps and gears. Assigning these functions to buttons don't work unless you click "control to repeat" but soon as you release the button the flap go back to the stored position. Bill Moore
October 2, 201510 yr Hi, I have all the CH Gear..........I use FSUIPC to control all of them...No problems at all.. Brian.
October 3, 201510 yr In CH control manager try to change on the top tool bar to Direct mode. See if it helps.
Create an account or sign in to comment