Hi Bryan,

 

Here's a weird one. In my last few flights with NGX reboot all my interactions with the FO are fine except for the select speed command.  If I, for example, say, "select speed "200"  the set speed in the MCP starts to change and then slow down as it reaches the commanded speed.  When it gets to 200 it pauses very briefly and then continues on to it's lowest, or highest, possible setting.  If I say "Cancel my last instruction" the FO does stop.  So I have been having to change speed settings myself.  I can't for the life of me work out how this could happen but perhaps you can help. 

 

Thanks

 

Andrew

Was your computer under a super high load at the time?  I'm guessing maybe it was.

Not particularly.  Just P3D running with the normal add ons, ASN, Track IR. I now remember that the frame rates had dropped a little during the approach so maybe that accounts for it. 

See if it happens again.  As you know, "CANCEL LAST COMMAND" will halt the FO in his tracks.

 

Cheers,

Ok, will do.  I'll let you know the outcome.

 

Thanks