I have a 737 ACE yoke and haven't really considered messing with the sensitivity settings. But would like to get some advice as to what settings mimics the real thing (well as close as possible) anyone have a clue? Or even the real 737 pilots on this?

 

Is the P3D default control settings good enough? I do have FSUIPC but only use my 737 yoke through P3D control settings.

 

 

Is the P3D default control settings good enough? I do have FSUIPC but only use my 737 yoke through P3D control settings.

 

http://www.avsim.com/topic/484655-saitek-yoke-and-pedals-calibration-for-pmdg-737ng/#entry3385867

Leave it as default then

I found that at default the controls on the sim are delayed which to me at least when it comes to flying real GA planes is not realistic. I like my yokes sensitive so there is the minimum delay. I have all my sensitivities at 100% and null zones at 0. Changed completely my way of flying. The proof for me came from a post on A2A where you can see a big delay on the movement while there was a PIP with the video of the actual yoke being pulled. I can't find it now but from then on I never used default or null zones again.