Rudder problems P3d v4

[Darcy 63]

In Prepar3d v4.I have Saitek rudder pedals.  All work fine until after landing and trying to taxi, they are hard to control and seem to not want to turn the aircraft.  I have to fight with them and speed and can eventually turn.  Never had this happen in FSX.  Any ideas?

Darcy Coutts

[downscc 1,327]

Don't forget to disable A/P before leaving the runway.

[Darcy 63]

First thing I do is turn off autopilot.  bar on panel or "Z" key.

Darcy Coutts

 

[scandinavian13 5,192]

7 minutes ago, Darcy said:

bar on panel

Incorrect.

Yoke switch, and then yoke switch once more.

[Darcy 63]

z twice then? or what should I map to my yoke switch.

 

Thanks

Darcy Coutts

[scandinavian13 5,192]

11 minutes ago, Darcy said:

or what should I map to my yoke switch.

Any key and then map that command to AP DISCONNECT in the key commands menu. My point was that you should be using the yoke switch in the actual simulator. If you're going to click on something with the mouse, click on that one, and not the bar. The bar is not the correct method.

[Darcy 63]

Okay. I figured it out and learned a few things.  My CH Eclipse has a axis that I had made rudder as well and the two seemed to not like it.  Took the rudder axis off the Eclipse and all is good.

 

Darcy Coutts