August 28, 20178 yr PFC yoke In prepar 3D works, but very low sensitivity, need to move it a lot to get the ailerons to move. Elevator is fine, just roll. Sensitivity is at 100% in game. Can it be adjusted like to 150% in the CFG file? If yes , which file?
August 29, 20178 yr From what I remember way back with FSX, the .mdl file is what you are looking for not .cfg file. There were programs around that would let you mess about in it and quite a few graphs explaining what each setting did (with suggestions). Intel(R) Core(TM) i7-10700F CPU @ 2.90GHz (8 cores) Hyper on, Evga RTX 3060 12 Gig, 32 GB ram, Windows 11, P3D v6, and MSFS 2020 and a couple of SSD's
August 29, 20178 yr 23 hours ago, motoadve said: PFC yoke In prepar 3D works, but very low sensitivity, need to move it a lot to get the ailerons to move. Elevator is fine, just roll. Sensitivity is at 100% in game. Can it be adjusted like to 150% in the CFG file? If yes , which file? Make sure you configure controller first. Inside the aircraft there's an aircraft.cfg file. Back it up. Look for this section: [flight_tuning] cruise_lift_scalar = 1 parasite_drag_scalar = 1 induced_drag_scalar = 1 elevator_effectiveness = 2 aileron_effectiveness = 1 rudder_effectiveness = 1 pitch_stability = 2 roll_stability = 1 yaw_stability = 1 elevator_trim_effectiveness = 1 aileron_trim_effectiveness = 1 rudder_trim_effectiveness = 1 hi_alpha_on_roll = 0 hi_alpha_on_yaw = 1 p_factor_on_yaw = 0.3 torque_on_roll = 0.3 gyro_precession_on_roll = 0.3 gyro_precession_on_yaw = 1 Lower numbers make the controls less effective. MSFS
Archived
This topic is now archived and is closed to further replies.