December 6, 20178 yr Hello to all, hope you can help me. I have installed EZDOK 1.87 and tried also the V2 one. The issue I have with both is the following: When I open EZCA on the section "virtual cockpit" and click on a view.....I get that specif view. Instead when I go on the "aircraft" section and click on ANY of those views reported...i get only the "top down" view... For instance if I click on "left wing" I get "top down" one.... Any help please...
December 6, 20178 yr If you are on prepar3d v4.1 then you need EZdoc ver 2.6 (build 27 is the latest. ) bob
December 7, 20178 yr 2 hours ago, flybyme said: Hello to all, hope you can help me. I have installed EZDOK 1.87 and tried also the V2 one. The issue I have with both is the following: When I open EZCA on the section "virtual cockpit" and click on a view.....I get that specif view. Instead when I go on the "aircraft" section and click on ANY of those views reported...i get only the "top down" view... For instance if I click on "left wing" I get "top down" one.... Any help please... Free update for 2.6.0.27, had a same problem....they have pre-loaded camera set for p3d. Just need a few adjustments and you are good to go...that's the only add-on after switch where I didn't wasted my time....easy to use. Alex
Archived
This topic is now archived and is closed to further replies.