Prepar3D v4.3 has been released

[jon b 2,050]

18 hours ago, Markek said:

I followed Poppet's  instructions to update to 4.3 Client (only) and receive this error:  Hacklib::Contact Points Offset() Unsupported P3D version.  Content, Scenery and Professional are 4.1.7.22841.  Professional Client is 4.3.29.25520.  Click through the error message and program appears to load normal but does not show up (nor is minimized either.)  Under Task Manager, program show in processes but not in applications if that means anything.Would appreciate any guidance or questions-not sure what more detail is needed.  Thanks.

 

Mark

I had the same error message, after a bit of research it appears this was being caused by the FSL 320, if you have that installed? I uninstalled the 320 and P3D now loads up ok.

I believe there is an update to the FSL 320 that addresses this issue , but I’ve not got around to installing it yet.

cheers

Jon

[Markek 2]

Thanks Jon.  Deleted FSL 320 and that resolved it..

 

Mark

[pracines 823]

On ‎6‎/‎26‎/‎2018 at 11:04 AM, georgio1952 said:

You know if the problem DXGI_ERROR_DEVICE_REMOVED was fixed with the new driver " 398.36 "?? I know the problem was create by NVidia Inspector and Frame Rate Limiter...

possible fix:

https://www.youtube.com/watch?v=5FWAVe1km_g

[brucewtb 249]

On 7/3/2018 at 9:45 PM, mpw8679 said:

I’ve never deleted my cfg after a client only update.  Have never had an issue

I have done both but notice no ill effects with using prev cfg in fact his time I decided I preferred the look of the sim with the prev cfg so I have reverted to that.

Bruceb

[Bob Scott 7,721]

OK, the purpose of this thread--to announce the arrival of P3D v4.3--has been served.  Let's move post-release discussion of specific issues to their own threads.

Regards