My FO does not set the ENG HYD PUMPS to high after start. On the after star checklist, he will say the pumps high, but they are left in the off positions and I have to set them manually. Is this a bug, or am I doing something wrong here? Using button control btw.

Hi Marius,

Are you starting the engines using FS2Crew procedures?  You need to.

Setting the Hyd pumps is part of the FO's after start flow.

From the manual in the FO's flows section.

After Engine Start Trigger -> When both engines stabilized.

1. Engine generator volts and frequencies correct.

2. Engine Ignition off.

3. Set CAPT Pitot Heater.

4. Checks Hydraulic pumps and switches are all HI/ON.

 

Sorry for not getting back to you earlier, haven't had much time for flight sim lately. I'm quite sure I followed the procedures as described in the tutorial, but I will try again with the new version and report back.