It was the p3dv4 version.

There are multiple installers, I think. I'd go to FT support forums.

ok

I also note that you have two entries for FlyTampa Libraries. Would that cause any problems?

So I should delete one?

Which one?

Well, I would assume that there should be only one entry for FlyTampa Libraries, but don't quote me on that! All I know is that I have three FlyTampa airports installed in P3D v3.4 (Amsterdam, Copenhagen and Corfu), and I have one entry for FlyTampa Libraries (below the airport entries).

Well, I have p3dv4.3 so that could be different, -32 bit and -64 bit.

I will delete the one that is not have whitish around the check box.

That did not work.

As Simbol mentioned earlier in the thread, have you contacted FlyTampa about this?

Edited November 1, 20187 yr by Christopher Low

yep no answer. 

@bnm
Go to your Saba and StBartholomew folders and double click on Add-to-P3D.cmd. This will add the sceneries to your add-ons.cfg

Edited November 1, 20187 yr by Bills511

Where do I find these folders?

3 minutes ago, bnm said:

Where do I find these folders?

In your Fly Tampa folders.
...Prepar3D v4\FlyTampa