I recently swapped my F1 750 for the RXP in my Flysimware Falcon 50 

I am not intercepting localiser. Switch from GPS mode to VLOC. Heading to intercept. Approach activated. Hits localiser and flies through it or turns 90 degrees!

F1. does the same intercept smoothly. 😂

So, should RXP be set different or has anyone noticed the Falcon misbehaving on approach with RXP. 

Tomorrow I’ll have to add RXP to another aircraft to cross check! 

21 minutes ago, Dean33 said:

I recently swapped my F1 750 for the RXP in my Flysimware Falcon 50 

I am not intercepting localiser. Switch from GPS mode to VLOC. Heading to intercept. Approach activated. Hits localiser and flies through it or turns 90 degrees!

F1. does the same intercept smoothly. 😂

So, should RXP be set different or has anyone noticed the Falcon misbehaving on approach with RXP. 

Tomorrow I’ll have to add RXP to another aircraft to cross check! 

The RXP GTN is a more sophisticated instrument.  Make sure the connections are set correctly in the GTN's settings panel.  Shift + right-click on the top edge of the RXP GTN. That will open the settings panel. If that does not bring up the settings panel then use the GTN  popup and shift + right-click on it's top edge.  Check the settings under the heading of Panel Instruments. The settings needed may vary by aircraft.  I do not have the Falcon so cannot confirm the proper settings for use in it.  Perhaps someone else here can advise.  In the meantime set what looks most logical and try another approach.

See Page 5 of the User's Manual that was installed on your system during installation.  Use the Windows Start Menu, then scroll to RealityXP where you should find the User's Manual listed. Just click to open it. It is a PDF.  Suggest digesting it to fully enjoy this GTN.

Edited December 2, 20187 yr by fppilot

Thanks. I’ll look at that after some sleep!  Assumed it was automatic but it helps to RTFM!

Any Falcon users confirm which boxes are ticked-all??

Dean

Dean. One additional point.  Because settings may vary by aircraft, the settings you change in that settings panel are then unique to that one aircraft model.  If you fly other aircraft models you will need to check and make settings for them as well.  Such is the age of sophistication, both in the aircraft and the gauges.

Also, until we release our update for P3D4.4, the autopilot is inop and this is expected.

We are just taking too long a time, see my updated P3D4.4 announcement pinned in this forum.

Thanks. That worked great. 

I can’t believe how easily the RXP can convert existing GTN installations (like my Bert/Carrenado PC12 addon). Wonderful. 

22 minutes ago, Dean33 said:

Thanks. That worked great. 

What worked, Dean? Which setting?  Might be helpful to others using the Falcon.

Hmmm the top boxes were blanked out on the Falcon. I assume that’s part of the Falcons configuration. 

I’ll add a screenshot later.