Button control does not work, voice does?

[Robsi60]

I fly the aerosoft a320 professional on WIN 10 with P3D V4.4. I bought Button Control for it and installed it. After I load cold & dark state I start button control with the assigned button. It starts with initialazing and it's V3.3. Then I set up the config in the panel and start pre flight procedure in config. Everything seems to work so far. I set up aircraft as in manual described but when it comes to call before start procedure and I push the assigned button nothing happens. It wont continue. I spend many, many hours trying to fix it and followed every hint I found on the web. It doesn't work.
Then I tried voice control, but I had to set up my computer first since my operating system is in German. After I have done that and trained speech recognition. I started fs2crew voice and did as described in manual and it works perfectly. I recogniced one major difference between the two. When I start button control pre flight procedure, it does not change color to orange promting pre-flight saying wait until Co-Pilot has finished. In voice control it does. My questions now are: What am I doing wrong? What could be the problem? For a start I would prefer the button version, though my USB headset has arrived today. Thanks in advance.

[byork]

If nothing happens when you push the Main Button, try a different assignment.  

I recommend using the "C" key for this (ALTERNATE STATIC SOURCE ON/OFF).  That's the button you'll use most of the time in Button Control to go through the checklists/commands.

http://www.support.fs2crew.com/help/manuals/#pageid=main_button1

 

I don't really follow question 2.  

Button and Voice are a bit different.  Just follow the tutorial 🙂

 

[Robsi60]

This was it. I didn't assign this button. How stupid I am. Now it's up to me but voice control seems to be easier. Thanks a lot!! What I have to figure out now how GSX works with fs2crew.

 

[byork]

No worries!

 

[Robsi60]

I had a nightmare because of this simple mistake. I went through the manual again and think fs2crew is programed cleverly. All I have to do is change the panel in AS configurator to switch between voice and button, though the buttons have other purpose. RTFM is what I've learned out of this.

[byork]

Important thing is your got it working 🙂

Don't worry, when it comes to RTFM I'm probably worse than you 🙂

[vc10man]

16 hours ago, Robsi60 said:

figure out now how GSX works

Had no issues so far.