August 1, 20196 yr Hello everyone, When I connect 2 saitek throttle quadrants, I think windows recognizes the 2 as 1 so when i activate reverse in bounces from reverse to idle because reverse axis x on quadrant 1 is on and reverse axis x off on quadrant 2. So I don’t know what to do now. Tested this on 2 computers, same result.
August 1, 20196 yr Commercial Member 1 hour ago, Xander710 said: Hello everyone, When I connect 2 saitek throttle quadrants, I think windows recognizes the 2 as 1 so when i activate reverse in bounces from reverse to idle because reverse axis x on quadrant 1 is on and reverse axis x off on quadrant 2. So I don’t know what to do now. Tested this on 2 computers, same result. It would great if you could tell us which sim you are running. Also, you're connecting two USB Saitek Quadrants or 1 USB and 1 PS2 connector (the latter via the Saitek Yoke)? Looking forward to hearing back from you! Dave Hodges System Specs: I9-13900KF, NVIDIA 4070TI, Quest 3, Multiple Displays, Lots of TERRIFIC friends, 3 cats, and a wonderfully stubborn wife.
August 1, 20196 yr Author Hi, thanks ror the reply. I am using P3D with the jeehell software. The quadrants are both connected with USB.
August 2, 20196 yr 10 hours ago, Xander710 said: Hello everyone, When I connect 2 saitek throttle quadrants, I think windows recognizes the 2 as 1 so when i activate reverse in bounces from reverse to idle because reverse axis x on quadrant 1 is on and reverse axis x off on quadrant 2. So I don’t know what to do now. Tested this on 2 computers, same result. Sounds to me like you just have to program them correctly. You are probably being optimistic if you are expecting P3D to assign them rationally. Just go into the controls dialog and check what assignments are set; no doubt they overlap. Your specific problem will be about button assignments, assuming you are talking about the bottom detent when you say you 'activate reverse'. Something else to check - if I remember correctly P3D doesn't have independent reverse for multi-engine setups, so perhaps this is your problem. You can set it up with FSUIPC instead if you have that. MarkH https://www.youtube.com/@AlmostAviation AMD Ryzen 7 9800X3D / 64Gb DDR5 / Zotac RTX 5070 Ti / 2560 x 1440 display
August 2, 20196 yr Author Hi, I have the same problem with x plane, so I don’t think the problem is with p3d
August 2, 20196 yr 3 hours ago, Xander710 said: Hi, I have the same problem with x plane, so I don’t think the problem is with p3d I think you need to be much more specific about what is actually happening that you are not expecting. MarkH https://www.youtube.com/@AlmostAviation AMD Ryzen 7 9800X3D / 64Gb DDR5 / Zotac RTX 5070 Ti / 2560 x 1440 display
August 2, 20196 yr 16 hours ago, Xander710 said: Hi, thanks ror the reply. I am using P3D with the jeehell software. The quadrants are both connected with USB. If you are using the Jeehell software you have to setup your throttles in that software. I would check on his forum on mycockpit.org for help as most here are probably not familiar with the Jeehell software.
Archived
This topic is now archived and is closed to further replies.